Features:

• Built to withstand extreme temperatures (-20’C to 60’C).
• Rated IP55
• Allows up to 5 permanent and 10 temporary PINS to give friends, family or trades people easy access.
• Easy to see at night with backlight keys when pressed.
• Unique code generated with each activation
• Controls one gate or garage door opener
• Free Shipping Australia-Wide*

Includes:

• Genuine Merlin Keypad
• 1 x 9V Lithium Battery
• 2 x Keys
• Wall Plug/Screws
• Installation Instructions

Compatibility List:

• Slide 600 (MGSK600 MGSK600-LV),
• Swing A 200 (MGASK MGASK-LV MGADK MGADK-LV),
• Swing L 300 (MGLSK MGLSK-LV MGLDK MGLDK-LV)
• Commander Essential (MS65MYQ)
• Commander Elite (MS105MYQ)
• Commander Extreme (MS125MYQ)
• SilentDrive™ Essential (MR655MYQ)
• SilentDrive™ Elite (MR855MYQ)
• Commander Ultimate (MJ3800MYQ)
• Commander MyQ
• WhisperDrive
• TiltMaster
• PowerAce
• CyclonePro
• OverDrive
• SilentDrive Elite MyQ
• SilentDrive BBU
• SilentDrive Pro
• QuietDrive Pro
• WeatherDrive
• MJ3800BBU and Security+ 2.0 garage door openers

This keypad is not compatible with motors using Merlin Security+ Series or Merlin Green (M842/M844) or Merlin Blue (M802) Series

Installation

• Choose a mounting location suitable for your application such as a wall, flat surface or a pedestal with a 76mm x 76mm mounting pattern, located equal or less than 2m of installation height.  Locate the keypad at least 1.8m away from any moving part of the gate and where the user cannot reach over, under, around or through the gate to operate the controls.  The mounting location needs to be in line of sight of the moving gate.
• Unlock and remove the faceplate from the mounting plate
• Mount the mounting plate to the desired surface and secure with screws or bolts.
• Remove the battery cover using a screw driver and install the new battery making sure of the correct polarity, then re-install the inner cover.
• Reattach the faceplate to the mounting plate and lock with the key.
• The garage door/gate opener must be programmed to accept the new keypad code.  See basic programming.

Basic Programming

The E850M Keypad must be put into programming mode prior to any of the programming steps below unless otherwise indicated.  The 6-digit Master Code is used to prevent unauthorised access to the system.  A Master Code is required (factory default code: 888888) to setup the E850M Keypad.  It is highly recommended to change and record your unique Mater Code.

The Keypad backlight will remain on if the product is in programming mode.  While in programming mode, if an invalid Master Code is entered, an error tone will sound.  The keypad will remain in programming mode.  After 60 seconds of inactivity, the keypad will exit the programming mode.

Set Master Code

Program your regular 4-digit PIN

NOTE: An error tone will sound if the maximum number of PINs is exceeded or if user tries to program a PIN already programmed in the memory.

PROGRAM TO OPENER
NOTE: The Master Code and a PIN need to be set before the opener can be connected to keypad. See Basic Programming.
1. Press the Learn Button on the opener.
2. Within 30 seconds – Enter a valid 4-digit PIN then press #. A long tone will sound.
The keypad is now programmed to the opener.