The LEXO Wall Button remote has been designed to blend into the modern home to allow internal entry access point for up to 4 compatible garage and/or gates.

Features:

• Modern Sleek Design
• Wireless, Battery Powered
• Easily fixes to Garage Wall or Entry Point for Easy Access
• LED strips lights up when button is activate
• Free Shipping Australia-Wide*
• 2 Years Manufacturers Warranty*

Includes:

• Wall Button Remote
• 1 x 23A Battery
• Programming Instructions

Compatible with:

• TMT Powertech Motors
• LEXO Powertech Gate Openers
• LEXO RD1P10000A Roller Door Opener
• LEXO Cobble Overhead Opener

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).

Type: Wall Remote

Frequency: 433.92Mhz

Range: >20m*

Battery: 23A

How to program the LEXO Wall Button to:

TMT Powertech/ LEXO Powertech Openers

• Press “RF Learn” button for 2 Seconds on Motor – LED display shows “CS”
• Press the button you would like to activate – LED display will blink twice and then go off.

LEXO RD1P1000A Roller Door

• Press and Hold on “CODE” button for 1 second until the LED dot is on.
• Press button on Transmitter once, the LED dot will go off. Press the same Transmitter button again.
• The LED dot will flash fast 8 times and then return to standby mode.
• The transmitter is now coded into the receiver.
• Repeat the above steps to code more transmitters.