Features:

• Reliable Performance:  Operates on a 315Mhz rolling code frequency, ensuring secure access
• Compact and ergonomic design: Lightweight and easy to carry in your pocket, bag, or car.
• Multi-door control: Program up to three Gliderol garage doors for added convenience.
• Easy Setup: Supplied with Free Coding Instructions
• Free Shipping Australia-Wide*
• 2 Years Manufacturers Warranty*

Compatibility List:

This remote is compatible with the following Openers:

This remote is NOT compatible with

• GLIDEROL GTXU3

The TM305c has a 12v Battery & Green Circuit Board – GLIDEROL GTXU3 is in the same case, but it has a 6v Battery and a Blue Circuit Board.  They are NOT COMPATIBLE.

Looking for a genuine replacement for your Gliderol garage door remote? The Gliderol Garage Door Remote TM305C is designed to work seamlessly with a range of Gliderol garage doors, ensuring smooth operation and convenience. Whether you need to replace a lost or damaged remote, this model provides a high-quality solution that maintains the reliability and security of your Gliderol Garage Door System.

The Gliderol Garage Door Remote TM305C is a must-have for anyone using a compatible Gliderol garage door opener. Order now from Retro Remotes for a fast and reliable replacement remote!

How to Program your Gliderol TM305c Remote

NOTE: Always use BUTTON 1 to code your device – no matter which button activates it.

Programming Gliderol TM305C to the GRD receiver

1. Carefully remove cover from control box by lifting tab at bottom
2. Press the receiver button once (located on the receiver board top left corner of control box) A red light will illuminate
3. Press large button on the handset once and hold until red-light on receiver board turns off – This confirms that the handset is programmed

Programming Gliderol TM305C to the GTS receiver

1. Ensuring the power is switched o remove or loosen the screw on the GTS cover using screw driver
2. Remove the GTS cover by pulling in the directions of arrows as shown in the picture
3. Switch ON the power supply and press the LEARN button on receiver once (located on receiver board as shown)
4. A red light will illuminate on the receiver board Note: The receiver picture may vary depending on the model of the
   receiver compare to the picture shown in the picture
5. Press and hold large button on the handset once until red-light on receiver board turns off – This confirms that the
   handset is programmed