Features:

• Genuine Gliderol TM390+ remote – Original manufacturer-approved replacement
• Reliable Rolling Code Security – Prevents unauthorised access
• Compact & Durable – Designed for everyday use
• Control up to 3 Doors – Compatible with multiple Gliderol openers
• Free Standard Delivery Australia-wide*
• 2 Years Manufacturers Warranty*

Compatibility:

Note:  Genesis and Genesis Optima installed after July 2022 will likely be Gliderol G+ TM390 GEN 2 remotes (with blue buttons)

This product meets AS/NZS 62368.1 Clause 4.8 Safety Standards 2020 for products containing button/coin batteries.

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).

How to Program the TM390+ to Gliderol Genesis Overhead

• Press the “CODE” button, “-.-” will be visible on the display
• Press and hold the desired button on your remote that you would like to operate your garage door until the dots shown on display flash.

Clearing memory of the Genesis Opener

• Press and Hold the “CODE” button for more than 8 seconds.  The dots shown on the display will disappear to confirm all remotes have been cleared.

How to Program the TM390+ to Glidermatic GTS+ and GRD+ Overhead

• Press and Hold the Square Centre Button (ENTER) for 2 seconds to enter menu selection
• Use “Up” or “Down” buttons to select learn LED option (found on the right)
• Press the Desired button on the New Remote, a beep with signal successful coding

Clearing memory of the Glidermatic GTS+ and GRD+ Opener

• Press and Hold the Square Centre Button (ENTER) for 2 seconds to enter menu selection
• Use “Up” or “Down” buttons to select learn LED option (found on the right)
• Press and Hold the Square Centre Button (ENTER) for 5 seconds, when Indicator diminishes all codes have been erased.

How to Program the TM390+ to Glidermatic GTS+ Optima

Carefully remove the light cover by pulling down on the tab near the front of the unit.

• Press the ‘Learn’ button once. A red light will illuminate and the unit will beep three times to confirm the unit is in learn mode.
• Press the button on the handset that you would like to operate the door. The unit will beep once to confirm successful coding (two beeps indicates the handset has already been programmed). Wait approx 3 seconds for the unit to exit setup mode.

Clearing memory of the Glidermatic GTS+ Optima

• Press and Hold the ‘Learn’ button once for 10 seconds, LED will diminish and 3 beeps will confirm memory has been cleared.