Features:

• Genuine original equipment remote
• Free Standard Delivery Australia-wide*
• 2 Years Manufacturers Warranty*

Includes:

• Brand New Remote
• 1 x Battery
• Coding Instructions
• Keyring Attachment

Compatibility List:

• Rollamatic GEN2 Roller Door Opener
• Genesis Sectional Door Opener (July 2022 – current)
• Genesis Optima Sectional Door Opener (July 2022 – current)

WARNING:  THIS REMOTE IS NOT COMPATIBLE WITH THE GLIDEROL G+ TM390  – GREY BUTTON (installations prior to July 2022)

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).

PROGRAMMING INSTRUCTIONS FOR GLIDEROL TM390+ GEN2 REMOTE (Blue Buttons)

Click here for detailed instructions with images

GENESIS and GENESIS OPTIMA

Programming a new remote.

• Press the ‘Code’ button and ‘-.-‘ will become visible on the display
• Press and hold the desired button on your remote that you would like to operate your door until the dots shown on the display flash.

Clearing the memory

To erase all stored remote information, simply press and hold the ‘CODE’ button for more than 8 seconds. The dots shown on the display will disappear to confirm all remote programming
information has been erased.

ROLLAMATIC GEN2

Programming a new remote.

• Press and hold the ‘Enter’ button (shown above) for 2 seconds to access the operator menu. The unit will beep twice to confirm this has been selected.
• Use the arrow (Up & Down) buttons to select the ‘Learn’ option and press ‘Enter’ to confirm selection. The unit will beep three times to confirm the unit is in Learn mode.
• Press and hold the desired button for operation on the handset. Hold down until every light in the status bar on the powerhead (as shown above) is lit up

Clearing the memory

To erase all stored remote information, simply press and hold the ‘CODE’ button for more than 5 seconds.