Features:

• 1 x Genuine Remote
• 2 Years Manufacturers Warranty*
• Free Standard Shipping Australia-Wide*

Includes:

• 1 x Brand New Remote
• 1 x Battery
• Coding Instructions

Compatibility List:

• FADINI ASTRO 43-2v1 Original Remote
• FADINI ASTRO 43-4v1
• FADINI ASTRO 43-2
• FADINI JUBI 4v1
• FADINI JUBI 2v1
• FADINI JUBI 2

The Fadini Divo 71 is a self-learning, rolling code 433.92 MHz 4 button transmitter compatible with both the FADINI ASTRO and FADINI JUBI series.

WARNING! KEEP BATTERIES OUT OF REACH OF CHILDREN. Never allow children to replace button batteries on any device. Swallowing or placing inside any part of the body may lead to severe or fatal injuries in as little as 2 hours or less due to chemical burns and potential perforation of the oesophagus.

If you suspect your child has swallowed a button battery or placed inside any part of the body immediately call the POISONS INFORMATION CENTRE on 13 11 26 for prompt advice. If your child is having any difficulty breathing, contact 000.

Dispose of used button/coin batteries immediately and safely. A battery can still be dangerous even when it can no longer operate the device. Place sticky tape around both sides of the battery and dispose of it immediately out of reach of children in an outside bin or recycle safely.

Please see button battery safety information from the Australian Competition & Consumer Commission (ACCC).

Warning:  This Product contains a button or coin cell battery.

Hazardous if Swallowed

How to Program the Fadini DIVO remote

This remote is defaulted to Fadini Astro from manufacturers.  You can check the mode by holding down the bottom two buttons until the red led flashes.

1 Flash = Astro 43

3 Flashes = Jubi 433

Changing from Fadini Astro to Fadini Jubi

• Simultaneously hold down top and bottom right buttons for 5 seconds.  The remote will flash to confirm the new mode:
• Hold Top and bottom right (1 and 4) buttons for 5 seconds.

Remote will flash to confirm the new mode:

1 Flash = Astro 43

3 flashes = Jubi 433

Cloning the Fadini Divo 71 to your working Fadini remote

Have your working Fadini remote and New Fadini Divo within 5 cm of each other.

1. Press and Hold Top Left button while simultaneously pressing top left button twice.
2. Release Top Left Button – receive 3 confirmation flashes (your remote is in learn mode)

Note: DIVO will have a fixed LED light during Learn Mode

3. Press and Hold a working button on the old working remote (DIVO will flash 3 times)

Programming the Fadini Divo to a working Fadini Receiver

Warning:  Holding down the programming button on your opener for longer than 5 seconds could delete all working remotes programmed to the receiver.  If this happens you will need to program all remotes.

1. Open the casing of the radio receiver
2. Press the Programming button (located on the receiver – ENR/MEMO/PROG or REC)

You may need to hold down for a few seconds.  LED light on receiver will light up or flash to confirm Learning Mode.

3. Hold down the button on your DIVO remote for 1 second.
4. Light on receiver should go out within 10 seconds.

Troubleshooting:  If you are having difficulties programming a remote to your opener it is recommended that you revise the specific manual for your model of motor.