THIS VERSION HAS BEEN REPLACED BY DITEC Entrematic SLIM2E

Features:

• Genuine Original Equipment Remote
• 2 Years Manufacturers Warranty*
• Free Standard Shipping Australia-Wide*

Includes:

• 1 x Brand New Genuine Remote
• 1 x Battery
• Programming Instructions

Also available as a 4 button version – Ditec ZEN4

Compatibility List:

• DITEC BIX LS2
• DITEC BIX LP2
• DITEC BIX LG4
• DITEC GOL4

Note:  This remote is NOT compatible with the DITEC GOL4C

The Ditec Zen 2 Remote features a Slim and compact design which is both lightweight and durable.

Specifications:

• Brand: Ditec
• Model: Zen 2 Button
• Type: Gate and Boom Gate
• Frequency: 433.92 MHz
• Coding: Rolling code technology
• Battery: CR2032
• Battery Compliance: Yes
• Dimensions: 35mm x 61mm x 10mm
• Operating range: Up to 40 meters
• Compatibility: Ditec BIX LP2, LG4, GOL4 and LS2

GOL4 Remote to Zen Remote Programming

You will need to be positioned near your receiver.

1. Activate the opener with an already coded remote control
2. With a sharp pointed object (paper clip or pin), press the hidden button on the old remote for 5 seconds.
3. Once LED illuminates release the hidden button.
4. Press a button on the new Zen 2 or 4.
5. Wait 10 seconds for system to reset.

Zen Remote to Zen Remote Programming

You will need to be positioned near your receiver.

1. On the Working Remote, Press and hold the top and bottom buttons until LED (3 – 10 seconds)
2. On the Working Remote, Press and hold the top and bottom buttons until LED flashes twice.
3. Within 10 seconds on the NEW remote, Press the button you wish to activate the opener.
4. Wait 10 seconds before testing the remote.

RECEIVER TO REMOTE – Suggested if programming multiple devices to one remote.

Motors with no LCD screen on Control Board

1. Open the casing of your receiver
2. On the receiver, press the programming button (PRG)
3. When the receiver led illuminates release the button
4. Press a button on the new Zen 2 or 4.
5. Receiver will blink and then remain lit

Motors with LCD screen on Control Board

You can directly access the remote control storage menu even with the display turned off, but only with the display visualization option set to 00 or 03:

• To program new remotes
• To program new buttons/channels on an existing remote.

On the receiver you have 4 buttons – Up/Down/Ok/ESC.  Above these buttons is a screen that will register the mode.

1. Receiver – Press Enter to activate the menu.
2. Receiver – Scroll up or down to select RO in menu
3. Receiver – Press Enter
4. New Remote – Press a button on the new Zen 2 or 4
5. Receiver – Press Ok

Continue this process for each remote or channel you wish to program.   Once Finished press Esc on receiver.