Features:

• Genuine ACDC Remote
• Free Shipping Australia-Wide*
• 2 Years Manufacturers Warranty*

Includes:

• 1 x Brand New Remote
• 1 x Key Ring Attachment
• 1 x Battery
• Coding Instructions

Compatibility List:

This remote is compatible only with the below ACDC motors:

• RollerGlide
• PowerGlide

Featuring 4 buttons in an unique design with a half round GREEN button & three black buttons in a white case. A wide key-ring connection makes attachment easy and the rounded edges makes the remote feel good in the hand. Working on 433.92MHz with ACDC’s own rolling code algorithm, this remote has a great feel & looks good.

Programming Instructions

ACDC Roller-Glide

• Remove the white plastic light cover (take care as the push button is attached.
• Press and Release LEARN button
• Press the button on the NEW remote for 2 seconds.
• Pause for 2 seconds
• Press the same button again for 2 seconds

Deleting memory

Press and hold the LEARN button for 15 seconds.

ACDC Power-Glide and Euro-Glide

• Press and release LEARN button A dot will illuminate in the corner of the LED display
• Press the button on the NEW remote for 2 seconds.
• Pause for 2 seconds
• Press the same button again for 2 seconds The dot in the corner of the display will flash to confirm the code has been accepted
• Turn off Motor.

ACDC Slim-Glide

• Remove the light cover.
• Press K1 button on the control board, the coding light will come on.
• Press the button on the NEW remote for 2 seconds. Coding light will turn off
• Pause for 2 seconds
• Press the same button again for 2 seconds The coding light will flash 8 times then turn off indicating the coding has been coded successfully.

Deleting Memory

-Press and hold button K1 down for approximately 8-10 seconds – code light will come on and then go off indicating a successful delete.

ACDC GL24

• Press and hold down button “P2” MEMO: The LED “L4” will flash slowly – at the same time press the remote button you want to open / close the device
• Hold down button “P2” MEMO until LED “L4” starts to flash again
• Release the button “P2” MEMO – The LED will continue to flash.
• Within 15 seconds activate the remote button again – at the end of coding: the LED “L4” will remain lit for 2 seconds

Deleting Memory

Keep both buttons “P2 & P3” pressed down for more than four seconds.- LED “L4” will remain lit during the entire delete time (about 8 seconds) – LED “L4” switches off when the deletion procedure has finished