Features:

• Water Resistant
• Ergonomic, simple and modern design
• Manual Key Lock for several Key Automation Motors
• Designed and Made in Italy
• Free Shipping Australia-Wide*
• 2 Years Manufacturers Warranty*

Includes:

• 1 x Brand New Genuine Remote
• 1 x Battery
• Coding Instructions

Compatibility List:

• Key Automation TURBO 400
• Key Automation SUN 5024F
• Key Automation SUN 11024
• Key Automation SUN 4224
• Key Automation RAY
• Key Automation REVO
• Key Automation TURBO 2000
• Key Automation HALO

Note:  Do not purchase THIS remote for your Boss/Steel Line FORZA garage door.  This remote does not hold the manufacturers code required to program to the FORZA.  You will need the BOSS HT20.

Warning:  This Product contains a button or coin cell battery.

Hazardous if Swallowed

PROGRAMMING TO THE PLUG IN (RX4X Receiver)

This receiver is found in the SUN5024FAU, SUN11024 via a plug in receiver.

• Press and release the receiver button once to place the receiver into Learning Mode.
• LED on the receiver will flash number of times equal to the number of outputs selected (1 second pause between each flash)
• On your NEW remote, push and hold the button you wish to control the opener for more than 2 seconds.
• The receiver LED will give one long flash to confirm successfully coded.

Continue with Step 3 for each button or remote you wish to program.

DELETING A REMOTE FROM THE PLUG IN (RX4X Receiver)

• Press Receiver button (approximately 3 seconds) until radio LED lights UP
• Within 7 seconds press and hold the key on the remote to be deleted until the Receiver LED goes OUT. Release the remote button.
• The Receiver LED starts to flash (About 1 second after the Remote button is released)
• Press Receiver button to confirm deletion
• Receiver LED will give one long flash if successfully deleted.

PROGRAMMING TO THE CT10224 CONTROL BOARD

• Press and Release the DOWN (RADIO) button to the position output you are wishing to program (Normal is ONCE for Step by Step. Other Outputs can be found within the Control Boards Manual
• KEY LED will flash a number of times equal to the number of the output selected with 1 second pauses between flashes
• Press the Key of the remote to be programmed for at least 2 seconds
• LED will give one long flash if successful.
• To Program additional remotes or buttons, repeat point 3

Note: If no Commands are given within 7 seconds the receiver will automatically disengage from the programming mode

PROGRAMMING FOR FORZA 1200 or BOSS HT20

• • Press the “S” button on the opener until “0” appears on the screen, then release the button.
  • Press the desired button on your remote that you wish to use.
  • The “0” on the screen will disappear and your remote has been coded.